Bond It MITRE KIT can be used for bonding MDF Chipboard, oak , Pine, all common timbers, PVCu and rubber.
Surfaces to be bonded must be clean, dry and free from dust, grease or contaminants that may hinder adhesion.
Spray aerosol lightly over one face of the joint and allow to dry. If possible, use on the least visible face of the completed joint. Apply adhesive to the other face and bring together immediately. Apply gentle pressure.
Can be used on uPVC but over application of the accelerator can result in staining.
This stain may not become visible for several hours after application. Apply to a test sample to check application level to avoid any staining on final job.
The speed of cure varies according to the substrate to be bonded. Timber and metals will have a longer cure time than plastics and rubbers. Best results are achieved on close fitting parts with a very thin bond line. Excessive bond gaps will result in slower cure